목적과 응용 필드

Our Jaw Crushers are ideally suitable for primary and secondary crushing, with well-capacity and high-efficiency, they are widely used for crushing various medium hard rocks and other ore materials whose maximum pressure-withstanding is 2000 kilogram force/cm3 and they are mainly supplied to the departments like Geological coal char、Mine、Metallurgy、Chemical Engineering、Construction Materials etc. And the labs of junior college academies science and research units.

기본 사양 및 기술 데이터

기본 일하다잉 원칙

The Jaw crusher structure includes Fabricated Body、Swing Jaw、Eccentric Shaft、Jaw Plates、Toggle mechanism etc parts. The electromotor drives eccentric shaft through triangle strap, to make the swing jaw moves in adjusted locus, thereby the materials in the crushing cavity are crushed.

The fabricated body is electricity welded by steel plates, the fixed jaw plates tightened by bolts are fixed in the front of steel housing, which assist in impacting the plates. The side plates are fixed in the steel housing side-wall which in the right-and-left of the crushing cavity, for preventing the wearing and tearing of the steel housing side-wall.

The swing jaw is a cast steel moulding, its face fixes swing jaw plates, top hang on the housing by eccentric shafts and roller bearings, its infrastructure is supported by toggle mechanism and it is scroll touching with the toggle mechanism. Fly wheels and Strap wheels with grooves are fixed in the two sides of the eccentric steel shafts. The steel housing is welded into the machine seat, electric motor sliding-track is fixed in the machine seat with bolts and a outlet drawer is fisted in the outlet, but it can expel products downwards directly without outlet drawer.

Toggle mechanism is connected with supporting bolts byφ9mm pins when the materials in the crushing cavity can not be crushed and the loads are increased suddenly, viz. The pin parts itself rapidly to protect other works from being destroyed. In the end of supporting bolt, there’s a hand wheel, it is used to adjust the outlet width size. The adjusting process is that remove the setscrew first, then circumgyrate the hand wheel, after adjusting, tighten the setscrew again, the connection between pothook and spring at the down most of the swing jaw make the toggle mechanism and swing jaw not to work outside, and they are adjusted by nuts.

설치 명령

이 기계는 제조 공장에서 전체 조립 후 사용자에게 제공됩니다. 운송 중 가능한 결함을 제거하기 위해 얻을 때 검사하십시오.
1. 빅기가 많은 생동감을 얻으려면 콘크리트 기초에 턱 크러셔를 장착하여 진동과 소음을 줄이기 위해 경재 사원, 고무 스트립 또는 기타 쿠션 - 크러셔와 콘크리트 기초 사이의 생동맥 재료.
2. 기초 무게는 기계 무게의 약 5 - 10 배이며, 기초 깊이는이 장소의 접지 동결 깊이보다 깊습니다. 기계 설치 및 테라 피트 볼트 위치와 관련하여 위치.
3. 출구 너비 크기를 조정하기 전에 먼저 시제 스프링을 풀어야합니다. 조정 후 토글 메커니즘이 외부에서 작동하는 것을 방지하기 위해 스프링 시제 정도를 적절하게 조정하십시오.

제품 비디오