Laboratwa machwè ékrazan

Objektif ak Jaden aplike

Our Jaw Crushers are ideally suitable for primary and secondary crushing, with well-capacity and high-efficiency, they are widely used for crushing various medium hard rocks and other ore materials whose maximum pressure-withstanding is 2000 kilogram force/cm3 and they are mainly supplied to the departments like Geological coal char、Mine、Metallurgy、Chemical Engineering、Construction Materials etc. And the labs of junior college academies science and research units.

Espesifikasyon prensipal ak done teknik

Prensipal travayal prensip

The Jaw crusher structure includes Fabricated Body、Swing Jaw、Eccentric Shaft、Jaw Plates、Toggle mechanism etc parts. The electromotor drives eccentric shaft through triangle strap, to make the swing jaw moves in adjusted locus, thereby the materials in the crushing cavity are crushed.

The fabricated body is electricity welded by steel plates, the fixed jaw plates tightened by bolts are fixed in the front of steel housing, which assist in impacting the plates. The side plates are fixed in the steel housing side-wall which in the right-and-left of the crushing cavity, for preventing the wearing and tearing of the steel housing side-wall.

The swing jaw is a cast steel moulding, its face fixes swing jaw plates, top hang on the housing by eccentric shafts and roller bearings, its infrastructure is supported by toggle mechanism and it is scroll touching with the toggle mechanism. Fly wheels and Strap wheels with grooves are fixed in the two sides of the eccentric steel shafts. The steel housing is welded into the machine seat, electric motor sliding-track is fixed in the machine seat with bolts and a outlet drawer is fisted in the outlet, but it can expel products downwards directly without outlet drawer.

Toggle mechanism is connected with supporting bolts byφ9mm pins when the materials in the crushing cavity can not be crushed and the loads are increased suddenly, viz. The pin parts itself rapidly to protect other works from being destroyed. In the end of supporting bolt, there’s a hand wheel, it is used to adjust the outlet width size. The adjusting process is that remove the setscrew first, then circumgyrate the hand wheel, after adjusting, tighten the setscrew again, the connection between pothook and spring at the down most of the swing jaw make the toggle mechanism and swing jaw not to work outside, and they are adjusted by nuts.

Enstriksyon Enstalasyon

Machin nan apwovizyone itilizatè yo apre yo te reyini antye pa faktori fabrike nou an, tanpri egzaminen li lè ou jwenn, yo nan lòd yo elimine defo yo posib pandan transpòte.
1.Due Biggish k ap travay vibrancy, se konsa nou sijere sou mòn brwayeur yo machwè sou fondasyon yo konkrè, pou diminye vibrasyon ak bwi, ou ta pi bon underlay tanp bwa di, bann kawotchou oswa lòt kalaj - Materyèl vibran ant brwayeur yo ak fondasyon yo konkrè.
2. Pwa fondasyon an se apeprè 5 - 10 fwa nan pwa nan machin, pwofondè nan fondasyon se pi fon pase pwofondè nan konjelasyon tè nan kote sa a. Avèk konsiderasyon enstalasyon an machin ak Terra pye boulon kote.
3. Anvan ajiste gwosè lajè priz la, ou ta dwe dekole prentan an tansyon an premye. Apre yo fin ajiste, yon fason ki apwopriye ajiste degre nan tansyon prentan, pou anpeche mekanis a aktive soti nan travay deyò.

Pwodwi videyo