Pag-uyog sa lamesa
 |
 |
 |
Pag-atubang sa Produkto
The beneficiation process of the shaker is carried out on the inclined bed surface with repeated strips. The ore particles are sent from the feed trough at the corner of the bed surface, and the transverse washing water is supplied to the feed trough. Under the action of gravity, the transverse water impulse, the inertia and friction caused by the reciprocating asymmetric movement of the bed surface, the ore particles are stratified according to specific gravity and particle size. The longitudinal motion along the bed surface and the transverse motion along the inclined bed surface are made. Therefore, the ore particles with different specific gravity and particle size gradually fan down in their respective direction of movement, respectively from different areas of theconcentrate end and tailings side, and finally are divided into concentrate, ore and tailings.The outstanding advantage of 6-S shaker is that the separation accuracy is high, and the final concentrate, middle ore and waste tailings can be obtained after a single separation, and multiple products can be obtained at the same time. The concentration ratio of concentrate is high, the sorting efficiency is high, the care is easy, and the stroke is easy to adjust.
Ang Binuhat nga Nagtrabaho
Shaker sorting is realized under the joint action of bed shaking and transverse water flow. Bed bed strips are longitudinal and the direction of water flow is close to vertical. When water flow crosses each bed strip laterally, eddy currents are formed in the groove. The combined action of eddy currents and bed shaking can loosen the mineral sand layer and stratify it according to density. The upper light ore particles are subject to the greater impulse of the water flow, while the lower heavy ore particles are subject to the lesser impulse, so the transverse movement speed of the light ore particles on the bed is greater than that of the heavy ore particles on the bed. This process is called "de lamination".
In the longitudinal direction, the differential movement of the bed surface, at first at a slow speed and gradually accelerate, to the maximum speed when the sudden retreat, the speed gradually decreases during the retreat process, and then forward, repeat the above process, not only promote the loose stratification of the ore layer, but also make the heavy ore particles move forward along the longitudinal at a larger speed, so that the light ore particles move forward at a smaller speed. Kung diin ang mga partikulo sa ore nagdepende sa kombinasyon sa longitudinal floocity ug transverse nga tulin. Ang mga bug-at nga minerals adunay gamay nga transverse velocority ug labi ka taas nga kadugayon nga tulin, ug ang mga light minerals adunay labi ka labi ka labi nga labi ka taas nga kadasig.
Applying the parallelogram rule to synthesize the longitudinal velocity and transverse velocity, it can be seen that the combined velocity of heavy minerals is inclined to the concentrate end of the shaker, light minerals are inclined to the tailings side of the shaker, and medium density particles are located between the two. This process is called "transport banding".Since the height of the bed is gradually reduced along the longitudinal direction of the self-driving end, the stratified ore particle groups in the groove are continuously stripped off during the movement to the concentrate end.
Ang mga light mineral sa ibabaw nga layer sa uku sa una gihuboan ug gibalhin sa kilid sa ikog sa kilid sa pinahigda nga direksyon sa tumoy sa higdaanan. Busa, ang mga mineral sa tibuuk nga nawong sa higdaanan nagpakita usa ka pag-apod-apod sa fan sumala sa lainlaing gravity ug lainlaing gidak-on sa tipik, aron makuha ang lainlaing mga produkto.
The concentrate strip is washed by transverse water flow in the smooth area of the bed surface (no bed strip area), so that a few gangue particles mixed in it are washed out, and the grade of the concentrate is further improved.
Kahon sa video